A quick look at the attic height in proportion to rest of frontage – right side of attic not yet up
and a reminder of the beams going this way and that
Now, sitting on these very beams, the slope and dormer in foam board – trying it on for size and angles.
and an internal view of same
Attaching faux beams before putting section in place and sealing the internal surfaces
Working on the attic and still doing a bit of pushing onwards here a little bullying into place there with a total refusal to allow for any ‘chickening out’ this time … slowly, slowly … Waiting for each itsy bit to dry before being able to move on again and hoping I don’t forget where we’re going in the meantime.
Windowed and with squared off cill in place, though some beams don’t seem to meet as nicely as I’d like. The outside is partially dressed up but covered in pegs holding it in till glue dries
Going to continue with this section with the much needed wall below this dormer but may also branch out, as it were, to cover some of the wall below that too. A change is as good as … 😉